B2901 BMW Fault Code

Description:

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

B2901 Code Symptoms :

There are currently two main types of cylinder deactivation used today, depending on the type of engine. B2901 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.

Diagnosis And Repairing B2901

B2901 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix B2901 code ?

• EVAP system hose leaking
• Erratic camshaft position due to low oil pressure
• Damaged VCT phaser
• Damaged camshaft position (CMP) sensor

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.